Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 78

6. Troubleshooting
Check List
ETERNUS DX60 S5/DX100 S5/DX200 S5
The ETERNUS DX is in the maintenance state when the MAINTENANCE LED is green.
3
Use the pin to push the FUNCTION button/IP reset switch (IP RST SW) three times within three seconds.
After the default settings of the LAN ports are restored, the MAINTENANCE LED blinks green a few times a
second for several seconds.
4
Release the maintenance state.
Use the pin to push the FUNCTION button/maintenance switch (MNT SW) for three seconds.
The MAINTENANCE LED turns off, which indicates that the ETERNUS DX is no longer in maintenance
status.
5
Attach the flange cover or the front cover.
6
Access ETERNUS Web GUI or ETERNUS CLI by using the default IP address to perform the network
environment settings and the firewall settings.
IMPORTANT
Make sure to enable the firewall setting for the protocol that is used for each service.
• To use ETERNUS Web GUI, enable the http or https connection. If the connection is disabled, the
ETERNUS DX cannot connect to the network via GUI.
• To use ETERNUS CLI, enable the telnet or SSH connection. If the connection is disabled, the
ETERNUS DX cannot connect to the network via CLI.
• To use the "ping" command for the ETERNUS DX, enable the ICMP connection. If the connection is
disabled, the ETERNUS DX does not respond to the "ping" command.
• To use monitoring software, enable the Maintenance Secure connection. If the connection is
disabled, the ETERNUS DX cannot connect to the network via monitoring software.
• To use the SNMP Manager, enable the SNMP connection. If the connection is disabled, the
ETERNUS DX does not respond to SNMP access.
7
Check whether each service can connect to the ETERNUS DX.
If it cannot connect, contact your maintenance engineer.
ETERNUS DX500 S5/DX600 S5/DX900 S5
78 Operation Guide (Basic)