Figure 32 Operation Panel (Controller Enclosure [Eternus Dx900 S5]) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure
LED name
FAULT
MAINTENANCE
CACHE
READY
REMOTE
*1: When the READY LED and the FAULT LED are both on at the same time, an error has occurred while the Unified configuration is
starting up.
●
ETERNUS DX900 S5
An operation panel has a CE-ID display and LEDs.
Figure 32
With a front cover
1
POWER LED
IDENTIFY LED
MAINTENANCE LED
READY LED
1
CE-ID
The CE-ID (controller enclosure number) of the controller enclosure is displayed.
2
MNT SW (maintenance switch)
This switch is used to switch the maintenance status on or off.
3
IP RST SW (IP reset switch)
This switch is used to initialize the LAN ports or to initialize the user information.
4
MST SW (CM Master Change switch)
This switch is used to change the Master CM.
LED status
(amber) (*1)
(blinks amber)
(green)
(blinks green)
(green)
(green) (*1)
(green)
Operation Panel (Controller Enclosure [ETERNUS DX900 S5])
FAULT LED
Meaning
The ETERNUS DX is in error status.
A part of the ETERNUS DX requires preventive maintenance.
Maintenance for the ETERNUS DX is in progress.
Maintenance (from ETERNUS Web GUI or ETERNUS CLI) for the
ETERNUS DX is in progress or a status check of the ETERNUS DX is
necessary.
There is data in the cache memory of the ETERNUS DX.
The ETERNUS DX is available for use.
The ETERNUS DX is turned on and off with the server.
Without a front cover
2 4
3
107 Operation Guide (Basic)