Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 93

A. Component Names
Frontend Enclosures (ETERNUS DX900 S5)
■
Switching the Power Mode to Local Mode
To switch the power mode to local mode, select "Menu1:LOCAL MOD".
Note
• The power mode can be changed even if the power (or DC power) of the ETERNUS DX is turned off.
The power mode that was set is enabled after turning on the power.
• The display can be returned to the previous display by pressing the CLEAR key before responding to the
confirmation message.
• The menu operation may not be available if the operation is performed such as when the ETERNUS DX is
starting, and the "Not Available" message may blink on the LCD panel. In this case, press the CLEAR key
to terminate the menu operation.
The operating procedure is described below.
1
Turn on the ETERNUS DX.
For methods to turn on the power, refer to
2
Press the FUNCTION key for two seconds or more.
"Menu0:REMOTE MOD" is displayed on the LCD panel.
3
Repeatedly press the FUNCTION key until "Menu1:LOCAL MOD" is displayed.
4
Press the INPUT key.
5
Press the INPUT key again after the confirmation message "[YES]/NO" is displayed on the bottom row of
the LCD panel.
When the INPUT key is pressed, the REMOTE LED is turned off and the ETERNUS DX is set to local mode.
"Powering On" (page 18).
93 Operation Guide (Basic)