Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 99

A. Component Names
Controller Enclosure
1
Controllers (CM#0, CM#1) (refer to
2
PWC port
This port is used to connect a power synchronized unit with an RS232C cable.
3
Host interface
This interface is used for connecting a controller with a server.
4
Drive interface (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
5
RMT (LAN) port
This port is used for connecting a LAN cable and used for separating the network (such as for the remote
support) from the MNT port for operation management. This port uses an RJ-45 connector.
6
MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
7
Power supply units (PSU#0, PSU#1) (refer to
"■ Controllers" (page 109))
"■ Power Supply Units" (page
99
114))
Operation Guide (Basic)