Figure 38 Controller (Eternus Dx500 S5) - Fujitsu ETERNUS DX S5 Series Operation Manual (Basic

A. Component Names
Controller Enclosure
LED name
DI (OUT) LINK/FAULT
READY/FAULT
MASTER
CA FAULT
LINK/FAULT
LAN ACT
LAN LINK
●
ETERNUS DX500 S5/DX600 S5
Figure 38
BUD READY LED
BUD FAULT LED
READY/FAULT LED
IDENTIFY LED
LED status
(green)
(amber)
(blinks amber)
(green)
(blinks green)
(amber)
(blinks amber)
(green)
(amber)
(green)
(amber)
(blinks green)
(green)
Controller (ETERNUS DX500 S5)
Meaning
The link between the DI (OUT) port and the destination port has been
established.
The link between the DI (OUT) port and the destination port is in
•
error status.
• The ports to remove the cables between enclosures from are
indicated. This occurs while a drive enclosure is being added.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The controller is in normal status.
An error has occurred during startup.
The controller is performing the initial setup after the power is
•
turned on.
The controller is in error status.
•
The controller is set as a Master CM.
The host interface is in error status.
The link between the host interface port and the destination port has
been established.
The host interface port is in error status.
Data is being sent or received via the LAN port.
The link between the LAN port and the destination port has been
established.
DI (OUT) LINK/FAULT LED
MASTER LED
LAN ACT LED
LAN LINK LED
111 Operation Guide (Basic)