Fujitsu ETERNUS DX S5 Series Operation Manual (Basic page 47

4. Component Expansion/Function Enhancement
Installing Additional Drive Enclosures
3
Wear a wrist strap or touch a metal part to discharge the human body's natural static electricity.
4
Install the drive enclosure in the rack.
• 2.5"/3.5" type drive enclosures (for regions other than the EMEIA, Central American, and Caribbean
regions)
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the
front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rails must be
attached to the rack before they can be completely tightened.
[Left]
(2)
Attach the rack rails to the rack.
Use the two plates to fasten the rack rails to the front rack pillars. Use the washers to fasten the
rack rails to the rear rack pillars.
Rack rail (left)
"L" indicated inside
(Front view of rack pillar)
[Right]
(Rear view of rack pillar)
Loosen the M4 screws to
adjust the length of the rack
rails to match the distance
between the front and
rear rack pillars.
Rack rail (right)
"R" indicated inside
47 Operation Guide (Basic)