Drive Roller Replacement; About; Procedure - Precor Experience 700 line Series Service Manual

Drive Roller Replacement

About

This procedure provides instruction to remove and replace the Drive Roller.

Procedure

Review entire procedure before starting.
Removal Instructions
1. Switch the power OFF and
2. Remove the hood cover, see
left/right Landing Trim covers, see
3. Relax the running belt tension by loosening the left and right 5/16" hex key tension
adjustment bolts. Alternately loosen the left and right adjustment bolts in 1/4 turn incre-
ments so that the running belt tension is evenly removed. Only use hand tools and not
power tools which could cause damage to the take-up roller tension mechanism.
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
1
unplug the power cord.
"Covers and Panels Replacement" on
"Covers and Panels Replacement" on
6 Replacement Procedures
Drive Roller Replacement
page 70, and
page 70.
Page 131