Table of Contents
Advertisement
• •
• •
■,,,.-
• •
• •
• •
• •
•
• •
• •
• •
•
• •
• •
•
./
• •
•
• •
• •
• •
•
• •
• •
• •
• •
• •
•
!
•
• •
•
•
REAR PANEL VIDEO CONNECTION CONFIGURATIONS
r
LED INPUT INDICATORS
Each input of the System 8/10 has a set of five
BNC connectors mounted vertically. A green
LED indicator above each set of connectors
lights when that input is selected. Only one
input can be selected at a time .
; , . ~;f.~L,TI-OUTPUT CONNECTION
'
AC POWER INPUT
[II]
[t:::1J
CAUTION; For continued
~,:~,~~
~~~~®
~~~,~~
~~.~~~
~:~:~
I ~
LED INPUT
INDICATOR
When the the System 8/10 is used to switch different types of signals, it is important to note that the output
signal will have the save format as the selected input. That is, RGB and Sync (composite or separate H&V)
will exit through the RGB and Sync output. Likewise, NTSC and PAL video signals pass through the
Composite Video output. Therefore, if multiple signal types are used in the same switcher, the same mul-
tiple outputs must be used by the projector or display monitor .
.
-
'
.,
VIDEO LOOP BACK (YLB)
When using a third-party scan-doubler (line-doubler) or Composite/S-Video-to-RGB decoder, the System 8/
10 features VLB. VLB allows the use of a single scan-doubler or decoder with multiple switcher inputs to be
looped back through the System 8/10 and then output as RGB Sync along with all other RGB Sync inputs .
These video configurations are described in detail later in this section .
..;
System 8/10 User's Manual • Page 3-1
Advertisement
Table of Contents
