Table of Contents
Advertisement
STAR CONNECTION (continued)
Page 5-8 • System 8/10 User's Manual
Connect an RJ-11 to RJ-11 cable between the SYSTEM INTER CO MM OUT connector of the
Step 5:
Primary Unit and the SYSTEM INTERCOMM IN connector of the Peripheral #1; another cable
from Peripheral #1 QUT to Peripheral #2 IN and so on to the end of the daisy-chain.
Connect the video output of Peripheral #1 to video input #1 of the Primary Unit. Connect the
output of Peripheral #2 to video input #2 of the Primary Unit and so on until all peripheral
are connected (IO maximum for System 10; 8 maximum for System 8).
Connect any communication devices (e.g., projector control cable, remote control, etc.)
Step 7:
to Primary Unit.
Connect the video outputs from the Primary Unit to the video inputs of the projector.
Step 8:
(refer to Section 6, Projector Communications.)
. • \
Step 9:
Save Configuration ... first turn the Peripheral Units ON, then turn the Primary Unit
ON. Wait 10 seconds for the Primary Unit to save the configuration to nonvolatile
EEPROM memory.
· St �p 10:
Primary Unit ... set ADDRESS switch No.4 to NORMAL (close).
Step 11:
Return all switchers to normal o p eration.
If there are any inputs left over on the Primary Switcher, their number ing will
resume after the last input of the highest number Peripheral switcher.
. I
Note
�
I
I
I
• •
I
•
I
I
•
I
I
I
I
"
I
• •
I
•
I
I
•
I
•
I
•
I
• •
I
•
• •
I
I
• •
I
I
I
I
I
I
I
• •
I
I
I
I
I
I
Advertisement
Table of Contents
