Barco - Extron electronics System 8 User Manual

Connection
Page 6-16 • System 8/10 User's Manual
To coi{figure Barco projectors, do this:
Remove System 8/10 top cover (pg. 6-14). See Fig 6-11; locate the projector RS-232
communications board; set switches and jumpers as listed in table below.
Note 1:
' , '.'. I
Step 2: Reinstall System 8/10 top cover.
Step 3: Configure the System 8/10 switcher as a Primary switcher by setting the address switch as
indicated in Fig 6-4, page 6� 3.
Turn System 8/10 power OFF.
Step 1:
Connect the BR Comm Adapter 9-pin male connector to the 9-pin female "COMM
Step 2:
PORT" or "RCVDS Communications" connector on the rear panel of the Barco projector.
If an automatic convergence (IRIS) unit is being used, the BR Comm Adapter then con­
nects to the 9-pin female connector on the IRIS unit.
Connect the CC-50' (or CC-100') cable from the 9-pin female connector of the BR Comm
Step 3:
Adapter to the 15-pin "PROJECTOR CONTROL" port located on the rear panel of the
System 8/10. If you wish, you can fabricate your own communications cables (up to 200
feet in length) using twisted pair cabling. Follow the pin-to-pin wiring illustrated in Fig 6-
3.
Step 4: Return System 8/ 10 and projector to normal operation.

BARCO

Table 6-6. Comm Board Switch Settings For Barco Projectors.
SWITCH/JUMPER
SW1
SW2
SW4
SW5
SW6
SW?
swa
'
J1
.. 1.·\;.;· · ,
J10
, r ·
1 Comm Cable
.,,
Latest update was on 9/9/93 switcher PC Ver. 1.9; compat­
ible with Barco software Ver. 4.0 or later.
FUNCTION
Switcher Size
Spare
Unit Number A
Unit Number B
Projector BAUD
Projector Type
Adapter Power
RS-232/422
Comm Loop Back
RS-232/422
SETTINGS
System 8 1 = ON; 2,3,4,5 = OFF
System 10 AI I OFF
0
0
2
2=OFF; 1,3,4=ON
1=ON; 2=OFF
Short 1 & 2
Short 1 & 2
J2