Extron electronics System 8 User Manual page 23

S-VIDEO INPUT CONNECfIONS
..
■
S-Video
_S-Video or S-VHS Signals
■.: S-Video
with R&L
Audio
"T'S-Video or S-VHS Signals
and Audio Follow
,'?;··
' " ~
' , ' ' . ~,,:_
CAUTION: For continued
R Audio
Y (Luminance)
L Audio
C (Chroma)
I ~
1-dWf-iffih·I
Figure 3-6.
S-Video Input Connections.
' '
\
S-Video ($.cVHS) is typically output from the AV source on a 4-pin miniature DIN type connector and
must be converted to 2 BNC type connectors -- one for chroma (C) and the other for luminance
(Y)
(use
Exton cable 26-353-01). S-Video input to the System 8/10 is made by connecting the chroma (C) to the
H/HV/C input connector and the luminance (Y) to the G / VIDEO/Y input connector. Audio inputs
. ' , : from the AV source are made to either the R&L inputs of the System 8/ 10, or to the R / R Audio and B /
· · t
Audio BNC conhe.Gtors.. -
INPUT SELECTION SWITCHES .
Each input must have a corresponding output. This is done by setting the DIP switches located above the
output connectors. There are two banks of DIP switches, each having 8 (or 10) switches. Each input has
two switches, one in each bank. For example, input #3uses the 3rd switch at each bank. For the S-Video
input shown on the adjacent page (S-Video signal connected to channel 3 input), the No.3 DIP switch of
S-VIDEO/SVHS bank should be in the UP (VIDEO) position and the No.3 DIP switch of the NTSC/PAL
should be in the DOWN (RGBS) position.
Table 3-3. Output Switch Settings for S-Video.
OPEN (Down) OPEN (Down) RGsB or RGBS
OPEN (Down) CLOSE (Up) VIDEO
f---_CL_O_S_E_(U_p_) _ _ _ o_P_EN_(D_ow_n_)_f---_S_-V_H_S_--1
¢
CLOSE (Up) CLOSE (Up) UNDEFINED
Page 3-8 • System 8/10 User's Manual
CH1 CHB CH1 CHB
Place the S-VIDEO/SVHS switch
in the VIDEO (up) position; place
the NTSC/P AL switch in the
RGBS (down) position.
,.;