Extron electronics System 8 User Manual page 46

DAISY-CHAIN CONNEC'PI-ON (continued)
Step 8:
Step 9:
Step 1(;';
Step 11:
Connect an RJ-11 to RJ-11 cable between the SYSTEM INTERCOMM OUT connector of the
Primary Unit and the SYSTEM INTERCOMM IN connector of the Peripheral #0; another cable
from Peripheral #0 OUT to Peripheral #1 IN and so on to the end of the daisy-chain.
Connect the video output of Peripheral #0 to the last input of the Primary Unit. Connect the
output of Peripheral #1 to the last input of Peripheral #0 and so on to the end of the daisy-chain.
Connect any communication devices (e.g., projector control cable, ·remote control, etc.) to Primary
Unit.
Connect the video outputs from the Primary Unit to the video inputs of the projector.(refer to
Section 6, Projector C o mmunications.)
Save Configuration ... first turn the Peripheral Units ON, then turn the Primary Unit ON.
Wait 10 seconds for the Primary Unit to save the configuration to nonvolatile EEPROM
.
Primary Unit ... set ADDRESS switch No.4 to NORMAL (close).
Return all switchers to normal operation.
Step 5:'
-...
· - : ·. "�-.
Step
7:
1'!.·
'
\�
� . '"', · . \
Page 5-6 • System 8/10 User's Manual
t
•
�
I
• •
I
• •
• •
• •
•
• '
fJ
• •
•
I
• •
I
•
I
I
I
I
•
I
I
I
I
I
I
I
•
I
I
I
I
I
I
I
I
I
I
I
• •
I
:I
•
I