Maintaining Fiber-Optic Cables In An Acx5000 Router - Juniper ACX5048 Hardware Manual

CAUTION:
Bending the cables beyond their minimum bend radius can damage the cables and
cause problems that are difficult to diagnose.
CAUTION:
allow fastened loops of cables to dangle, which stresses the cables at the fastening
point.

Maintaining Fiber-Optic Cables in an ACX5000 Router

To maintain fiber-optic cables in an ACX5000 router:
When you unplug a fiber-optic cable from a transceiver, place rubber safety caps over the transceiver
and on the end of the cable.
Anchor fiber-optic cable to avoid stress on the connectors. When attaching a fiber-optic cable to a
transceiver, be sure to secure the fiber-optic cable so that it is not supporting its own weight as it hangs
to the floor. Never let a fiber-optic cable hang free from the connector.
Do not bend fiber-optic cables beyond their minimum bend radius. Bending the cables beyond their
minimum bend radius can damage the cables and cause problems that are difficult to diagnose.
Frequent plugging and unplugging of fiber-optic cables in and out of optical instruments can damage
the instruments, which are expensive to repair. Attach a short fiber extension to the optical equipment.
Any wear and tear due to frequent plugging and unplugging is then absorbed by the short fiber extension,
which is easier and less expensive to replace than the instruments.
Keep fiber-optic cable connections clean. Microdeposits of oil and dust in the canal of the transceiver
or cable connector can cause loss of light, reduction in signal power, and possibly intermittent problems
with the optical connection.
To clean the transceiver canal, use an appropriate fiber-cleaning device such as RIFOCS Fiber Optic
Adaptor Cleaning Wands (part number 946). Follow the directions in the cleaning kit you use.
After cleaning the transceiver, make sure that the connector tip of the fiber-optic cable is clean. Use
only an approved alcohol-free fiber-optic cable cleaning kit such as the Cletop-S
the directions in the cleaning kit you use.
Do not bend fiber-optic cables beyond their minimum bend radius.
Do not let fiber-optic cables hang free from the connector. Do not
®
Fiber Cleaner. Follow
132