Cable Specifications For Qsfp+ And Qsfp28 Transceivers - Juniper ACX5048 Hardware Manual

CAUTION:
third-party optic or cable, the Juniper Networks Technical Assistance Center (JTAC)
can help you diagnose the source of the problem. Your JTAC engineer might recommend
that you check the third-party optic or cable and potentially replace it with an equivalent
Juniper Networks optic or cable that is qualified for the device.
Figure 27 on page 89 shows the location of SFP+ and QSFP+ ports for the ACX5096,
shows these ports for the ACX5048.
Figure 27: Port Panel ACX5096
1 Electrostatic discharge (ESD) terminal
—
2 SFP+ access ports (96)
—
Figure 28: Port Panel ACX5048
1
1 Electrostatic discharge (ESD) terminal
—
2 SFP+ access ports (48)
—

Cable Specifications for QSFP+ and QSFP28 Transceivers

The 40GbE quad small form-factor pluggable plus (QSFP+) and 100GbE quad small form-factor pluggable
28 (QSFP28) transceivers that are used in ACX Series routers use 12-ribbon multimode fiber crossover
cables with MPO socket connectors (SR4 optics only). The fiber can be either OM3 or OM4. Juniper
Networks does not sell these cables.
If you face a problem running a Juniper Networks device that uses a
2
3 QSFP+ uplink ports (8)
—
3 QSFP+ uplink ports (6)
—
Figure 28 on page 89
3
89