Port Panel Of An Acx5048 Router - Juniper ACX5048 Hardware Manual

Blinking blue indicates the beacon feature is enabled. This feature is enabled using the request
chassis beacon command.
Router product number
Management Ports C0 and C1
C0–Use the RJ-45 connectors for 10/100/1000 BaseT. See
Network for Out-of-Band Management" on page
C1–Use the SFP connector for 1000 BaseX.
USB port for image updates.
Console port (RJ-45) to support RS-232 serial ports.
SEE ALSO
USB Port Specifications for an ACX5000 Router | 98
Connecting an ACX5000 Router to a Management Console | 120
Connecting an ACX5000 Router to a Network for Out-of-Band Management | 121

Port Panel of an ACX5048 Router

The port panel of the ACX5048 supports up to a maximum of 72 logical 10 GbE ports when operating as
a standalone router. Forty-eight physical ports(0 through 47) support 10 Gbps small form-factor pluggable
plus (SFP+) transceivers. These ports can be configured as access ports. All 48 of these ports can be used
for SFP+ transceivers or SFP+ direct attach copper (DAC) cables. You can use 1-Gigabit Ethernet SFP,
10-Gigabit Ethernet SFP+ transceivers and SFP+ direct attach copper cables in any access port.
The remaining 24 logical ports are available for six 40 GbE ports (48 through 53) that support up to six
quad small-form factor pluggable plus (QSFP+) transceivers or QSFP+. Each QSFP+ socket can operate
either as a single 40 Gbps port or as a set of 4 independent 10 Ggps ports using QSFP+ breakout cables.
The 40 GbE ports can be configured as either access ports or as uplinks.
CAUTION:
another copper transceiver. Internal damage to the access ports and router can occur.
We recommend either using the top port row exclusively, or bottom port row
exclusively, for copper transceivers.
Figure 9 on page 51 shows the port panel of a ACX5048 router.
Do not place a copper transceiver in an access port directly above or below
"Connecting an ACX5000 Router to a
121.
50