Table of Contents
Advertisement
Power Heat Duct Installation (Optional)
Warning:
All wiring should be done by a qualified electrician and shall be in compliance with local
codes and with the current National Electric Code ANSI/NFPA 70 (in the U.S.), or with the
current CSC22.1 Canadian Electric Code (in Canada).
One or two optional power heat (98500769) ducts may be connected to this fireplace (top right and left of
the fireplace). Follow the directions below to prepare the power heat duct connection (for each power
heat duct used). Follow the directions included with the power heat duct for installation.
NOTE: The power heat duct should be wired for direct operation (see wiring diagram below);
1. Remove and discard the (2) outer
cover plates. Replace the screws to
seal up the holes on the top of the
fireplace.
2. Use snips or diagonal cutters to snip
the tab on the knockouts. Press on the
far side away from the tap to pop the
edge of the knockout up. Grab on to
the knockout with pliers and bend it
back and forth until the remaining tabs
break free. Discard the knock out
plate. The power heat duct is now
ready to install (see kit instructions for
details).
© Travis Industries
Optional Equipment
4/23/2021 - 1353
57
4415HO GSR2
Advertisement
Table of Contents
