FireplaceXtrordinair 4415 HO GSR2 Installation Manual page 66

66
Fourth (final) Layer

Once the third layer is removed, a final cover plate will be visible. Use a ¼" nutdriver to loosen the screw securing
the plate. Reach in and rotate the cover plate to uncover the final hole.
NOTE: The final plate does not get removed from the fireplace, just rotated to uncover the hole. Once the plate has
been rotated, tighten the screw to lock the plate in place.

Install the starter collars onto the fireplace (see below).

Install the fireplace into the framed chase. See section "Installation" in the manual.
© Travis Industries
Optional Equipment
4/23/2021 - 1353
NOTE: When all the plates
have been removed, it should
look this the image below.
4415HO GSR2