Table of Contents
Advertisement
52
Optional Equipment
CoolSmart / Power Heat Duct Installation
Cover plates on top of the fireplace allow for a CoolSmart TV or Power Heat Duct kit to be installed on this fireplace.
See the instructions below for details.
Power Heat Duct
DO NOT remove the two knockouts on the left side of the fireplace.
These knockouts are used for the CoolSmart TV installation ONLY.
Remove the 2 pairs of cover plates below the top cover plate (2 screws hold each plate in place). DISCARD THE
4 COVER PLATES. Once all of the cover plates are removed the fireplace should look like the illistration below to
the right.
Re-install the top cover plate (with 6" knock out) and secure it with the screws removed earlier.
Use snips to cut the tab on the knockout located on the top
cover plate. Press on the far side of the tab to pop the edge
of the knockout up. Grab on to the knockout with pliers and
bend it back and forth until the remaining tabs break free.
Discard the knockout. The flexible duct will attach to this
location (see picture below and instructions included with
the power heat duct).
CoolSmart TV
The top of the fireplace will need to be configured for the use of the CoolSmart TV kit. This includes
switching the position of the top cover plates and removal of the 2 knockouts. Refer to the installation
instructions with the kit for details.
© Travis Industries
Remove this top cover plate
Remove these 4 cover plates
(for qualified installers only)
8/17/2018 - 1481
864 40K CF
Hide quick links:
Advertisement
Table of Contents
