Table of Contents
Advertisement
Intake Restrictor
The intake restrictor is accessed by removing the burner (see LP Conversion Instructions on page 52 for
details). The intake restrictor is shipped in the open position (position # 1). Follow the directions below to
change the intake restrictor to position # 2 or # 3.
The intake restrictor is
located behind the burner,
on the rear wall of the
firebox.
Position # 1 (stock - open)
Position # 2
Loosen the three screws
shown to the right (1/4"
nutdriver). Then slide the
restrictor down and re-
tighten the screws.
Position # 3
Follow the directions above
for position # 2. Then
loosen the four nuts shown
to the right (11/32"
nutdriver). Then slide the
restrictor extension down
and re-tighten the nuts.
© Travis Industries
Installation
(for qualified installers only)
4/23/2021 - 1353
25
4415HO GSR2
Advertisement
Table of Contents
