Table of Contents
Advertisement
54
6. Follow the directions below to replace the orifice.
7. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace the
pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
© Travis Industries
Installation
(for qualified installers only)
4/23/2021 - 1353
4415HO GSR2
Advertisement
Table of Contents
