Fingerprint Reader Board - HP Elite x2 G8 Maintenance And Service Manual

4. Be careful not to tear the cable as you gently pull up the connector, and then remove the assembly from
the computer (4).
Reverse this procedure to install the volume board.

Fingerprint reader board

To remove the fingerprint reader board, use this procedure and illustration.
Table 6-12 Fingerprint reader board description and part number
Description
Fingerprint reader board, bracket, and cable
NOTE: The left speaker must be removed before removing the fingerprint reader board.
Before removing the fingerprint reader board, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display panel (see
3. Disconnect the battery cable from the system board (see
4. Disconnect the left speaker (see
Remove the fingerprint reader board:
1. Remove the Phillips M1.4 × 1.6 screw (1) that secures the fingerprint reader bracket to the computer.
62 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Display panel on page 42).
Speakers with antennas on page
40).
Battery on page 46).
55).
Spare part number
M51644-001