Fingerprint Reader Board - HP Elite x2 1011 G1 Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board
NOTE: The fingerprint reader board spare part kit does not include the fingerprint reader board cable.
The fingerprint reader board cable is included in the Keyboard Base Cable Kit, spare part number
793721-001.
Before removing the fingerprint reader board, follow these steps:
1. Shut down the keyboard base. If you are unsure whether the keyboard base is off or in Hibernation, turn
the keyboard base on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the keyboard base.
3. Disconnect the power from the keyboard base by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the keyboard base.
4. Remove the bottom cover (see
5. Remove the keyboard base battery (see
Remove the fingerprint reader board:
1. Disconnect the fingerprint reader board cable from the LIF connector (1) on fingerprint reader board.
2. Remove the Phillips PM1.5×2.7 screw (2) that secures the fingerprint reader board and bracket to
the top cover.
3. Remove the fingerprint reader board bracket (3).
The fingerprint reader board bracket is included in the Keyboard Base Bracket Kit, spare part number
793728-001.
Bottom cover on page 71).
Keyboard base battery on page
Spare part number
793713-001
72).
Fingerprint reader board 77