HP Elite x2 G8 Maintenance And Service Manual page 74

1. Prepare the computer for disassembly (see
2. Remove the display panel (see
3. Remove the battery (see
4. Remove the solid-state drive (see
Remove the system board:
1. Disconnect the following cables from the system board:
SIM card holder board cable (1)
●
POGO cable (2)
●
WLAN antenna cables (3)
●
Fingerprint reader cable (4)
●
(To reconnect this cable to the system board, you may need to lift the left speaker.)
Hall effect board cable (5)
●
(To reconnect this cable to the system board, you may need to lift the left speaker.)
Headphone/power button board cable (6)
●
(To reconnect this cable to the system board, you may need to lift the left speaker.)
Speaker cable (7)
●
(To reconnect this cable to the system board, you may need to lift the left speaker.)
Microphone cable (8)
●
Camera cable (9)
●
Camera cable (10)
●
IR LED cable (11)
●
WWAN module antenna cables (12)
●
Hall effect board cable (13)
●
(To reconnect this cable to the system board, you may need to lift the right speaker.)
Speaker cable (14)
●
64 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Display panel on page
Battery on page 46).
Solid-state drive on page
42).
48).
40).