Pogo Connector; Camera Module - HP Elite x2 G8 Maintenance And Service Manual

Reverse this procedure to install the WWAN module.

POGO connector

To remove and disassemble the POGO connector, use these procedures and illustrations.
Table 6-7 POGO connector descriptions and part numbers
Description
POGO connector and cable
IMPORTANT:
Before removing the POGO connector and cable, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display panel (see
3. Remove the battery (see
Remove the POGO connector and cable:
1. Disconnect the POGO cable from the ZIF connector on the system board (1).
2. Remove the two Phillips M1.4 × 2.5 screws (2).
3. Peel the cable up to disengage the adhesive that secures it to the computer (3), and then remove the
POGO connector from the computer (4).
Reverse this procedure to reassemble and replace the POGO connector.

Camera module

To remove the camera module, use these procedures and illustrations.
Be sure to use the correct size screwdriver to avoid stripping the screw.
Display panel on page
Battery on page
Preparation for disassembly on page
42).
46).
Spare part number
L67422-001
40).
POGO connector 53