Antenna Removal - HP Elite x2 G8 Maintenance And Service Manual

12. To install the left speaker, insert the speaker into the computer (1), place the notch on the speaker (2)
into the snap in the computer (3), and then make sure the left channel of the speaker fits under the left
notch in the computer (4).

Antenna removal

To remove and disassemble the antennas, use these procedures and illustrations.
Before removing the antennas, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display panel (see
3. Remove the battery (see
4. Remove the speakers (see
Remove the antennas:
1. Disconnect each antenna cable from the system board (1).
2. Using a tweezer, remove each antenna from the connectors on the bottom cover (2), peel each cable
from the computer, and remove the antennas.
NOTE:
Display panel on page
Battery on page
Speakers with antennas on page
Be careful not to tear the cables when peeling them from the bottom cover.
Preparation for disassembly on page
42).
46).
55).
40).
Antenna removal 59