Wwan Module - HP Elite x2 G8 Maintenance And Service Manual

Before removing the kickstand, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the kickstand (see
3. Remove the display panel (see
Remove the kickstand:
1. From the bottom, rotate the hinges up (1).
2. Remove the two Phillips M1.4 × 2.5 screws from each kickstand hinge (2), and then remove the hinges
(3).
Reverse this procedure to install the kickstand hinges.

WWAN module

To remove the WWAN module, use this procedure and illustration.
Table 6-6 WWAN module descriptions and part numbers
Description
Intel XMM 7360 LTE w/GPS M.2
WWAN kit
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Be sure to keep the protective strip to reinstall when installing the WWAN module.
Be sure to use the correct size screwdriver to avoid stripping the screw.
Kickstand on page
Display panel on page
To prevent an unresponsive system, replace the wireless module only with a wireless module
Preparation for disassembly on page
40).
42).
40).
Spare part number
L70670-005
M51648-001
WWAN module 51