HP Elite x2 G8 Maintenance And Service Manual page 62

Before removing the WWAN module, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the display panel (see
3. Disconnect the battery cable from the system board (see
Remove the WWAN module:
1. Remove the reusable protective strip from on top of the antenna connectors (1).
2. Disconnect the antenna cables (2).
3. Using a Phillips #0 screwdriver, remove the Phillips M1.4 × 1.6 screw (3), and then remove the module
(4).
NOTE:
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable
connects to the WLAN module #1 Aux terminal.
4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
52 Chapter 6 Removal and replacement procedures for authorized service provider parts
Display panel on page
Models have either one or two WLAN antennas. On models with two antennas, the #1 white
Preparation for disassembly on page
42).
Battery on page
40).
46).