Global Open/Close Options - Bosch DS7200V2-UK Installer's Manual

35.0

Global Open/Close Options

Arming Options 1
• Address: 0258
• Default: 0
• Selections: 0-7
Arming Options 1
No Options Enabled
Perimeter Only if No Entry/Exit
Answering Machine Bypass only when All/Perimeter Only On
Remote Arming with Telephone, Area 1
Reserved
• Perimeter Only if No Entry/Exit: If this option is enabled and the system is turned All On and no Entry/Exit Delay zones are
faulted during Exit Delay, the system automatically shifts to Perimeter Only. Perimeter Only (not All On) appears in the log
and reports. This option can only be used if the control panel is armed with delay. This option does not apply when arming
with keyswitches or RF keyfobs.
• Answering Machine Bypass Only When All On/Perimeter Only On: If this option is enabled, the Answering Machine
Bypass function is activated at the RPS Answer Ring Count, Answer Machine Bypass parameter (see page 46). If activated
there, this option can be used to restrict its function so that it only operates when the system is All On or Perimeter Only On.
The system does not answer if disarmed.
• Remote Arming with Telephone, Area 1: If enabled, this option controls the built-in telephone arming feature for Area 1.
When enabled, the control panel answers the phone on the ring count for remote programming. The following occurs when
the control panel answers the phone:
− If the control panel is All On or Perimeter Only On, it sounds three beeps and starts the handshake tone for remote
programming.
− If the control panel is Off, it sounds one short beep, waits approximately three seconds and then starts the handshake
tone for remote programming (one long beep). Press and hold the [5] key for two seconds immediately after the first
short arming beep and before the handshake tone begins.
If arming from a cell phone, quickly press the [5] key three times. If pressing and holding the [5] key for two seconds
from a house (landline) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing the [5] key
three times.
− The control panel arms if it detects a [5] key press from the telephone (All On with Delay, faulted zones are force-armed
like keyswitch arming). The control panel sounds three beeps (new armed state) and then hangs up.
You cannot use a telephone to disarm the control panel.
Page 54 P/N: 4998152533-02
PART IV: CONTROL PANEL PROGRAMMING
0
•
Copyright  2007 Bosch Security Systems, Inc.
Enter This Data Digit to Select Options
1 2 3 4 5 6 7 8
• • • •
• • • •
• • • •
9 10 11 12 13 14 15
DS7200V2-UK Installer's Guide