Dx3013 Installation; Figure 29: Dx3013 Mounting Locations; Figure 30: Mounting The Dx3013 (Step 1); Figure 31: Mounting The Dx3013 (Step 2) - Bosch DS7200V2-UK Installer's Manual

19.4

DX3013 Installation

The DX3010 contains static-sensitive
components and must be handled with care.
Follow anti-static procedures when handling
this module.
You can install a maximum of two DX3013 modules
(DX3010 mounted on an angle bracket) in the
DS7240V2's enclosure. Only 1 DX3010 can be
connected to the DS7220V2.
See Figure 29 for mounting locations.
DX3013 Mounting Locations
PO4
PO3
PO2
INSTALLER

Figure 29: DX3013 Mounting Locations

DS7200V2-UK Installer's Guide
DX3013 Mounting Locations
Copyright  2007 Bosch Security Systems, Inc.
Use the following steps to install a DX3013 in the
CX1011 Enclosure:
1. Insert the DX3013's angle bracket hooks into the
mounting slots in the back wall of the CX1011
Enclosure. See Figure 30.
Screw Hole
Hook
Slot
Enclosure Back Wall

Figure 30: Mounting the DX3013 (Step 1)

2. Pull the DX3013 down so that the angle bracket
hooks are flush in the mounting slots. See Figure
31.
Screw Hole
Hooks flush
with Slots
Enclosure Back Wall

Figure 31: Mounting the DX3013 (Step 2)

P/N: 4998152533-02
PART II: SYSTEM INSTALLATION AND SETUP
Back of
Angle Bracket
Back of DX3013
Mounting Plate
Back of
Angle Bracket
Back of DX3013
Mounting Plate
Page 23