50.0
RF Keypads
The control panel supports up to four RF keypads. Each keypad has two programming parameters. The RF keypads report
low battery, tamper, etc. by transmitter number.
You must exit control panel programming in order to enter RF ID codes. Add RF ID codes after you complete your
programming session. See Adding RF ID Codes on page34 for more information.
There is no RF keypad currently available.
RF Keypad
Rcvr 1 DBus Address
1
2
3
4
RF Keypad # Options
• Address:
− RF Keypad 1: 2930
− RF Keypad 2: 2932
− RF Keypad 3: 2934
− RF Keypad 4: 2936
• Default: 0
• Selections: 0, 2, 4, 6
RF Keypad # Options
No Options Selected
Reserved
Belongs to Receiver 2
Supervised
Reserved
• Belongs to Receiver 2: If this option is enabled, RF Receiver 2 performs ID and monitoring functions for the keypad. If this
option is disabled, the keypad belongs to Receiver 1.
• Supervised: If this option is enabled, the control panel generates missing reports if it does not hear from the RF keypad.
RF Keypad # Area
• Address:
− RF Keypad 1: 2931
− RF Keypad 2: 2933
− RF Keypad 3: 2935
− RF Keypad 4: 2937
• Default: 0 (Disabled)
• Selections:
− 0 = Disabled (no area assigned)
− 1 = Assign RF Keypad to Area 1
− 2 = Assign RF Keypad to Area 2
− 3 = Assign RF Keypad to Area 3 (DS7240V2 only)
− 4 = Assign RF Keypad to Area 4 (DS7240V2 only)
To enable an RF keypad, assign it to an area. To disable an RF keypad, enter a 0 at this parameter.
DS7200V2-UK Installer's Guide
Transmitter Number
52
255
53
254
54
253
55
252
Table 37: RF Keypad Data Bus Addresses
Copyright 2007 Bosch Security Systems, Inc.
Rcvr 2 DBus Address
60
61
62
63
Enter This Data Digit to Select Options
0
1
2
3
4
5
6
7
•
•
•
•
•
PART IV: CONTROL PANEL PROGRAMMING
Transmitter Number
247
246
245
244
8
9 10 11 12 13 14 15
P/N: 4998152533-02
Page 101