Reporting Format Configuration; Table 38: Personal Dialing Format Configuration - Bosch DS7200V2-UK Installer's Manual

55.0

Reporting Format Configuration

Personal Dialing Format Configuration
The Personal Dialing Format is selected by entering "7" into the appropriate reporting format address. See Format for
Destination 1 (2) on page 43 for more information. This format is a 2 PPS (pulses per second) 0/2 (0 account code/2 report
event digits) format that is intended for manual reception (for example, the panel calls a phone number where a person is
expected to answer).
The control panel starts by placing a phone call. The control panel then sends the first digit of the report, waits one second,
and then sends the second digit of the report. The control panel then waits three seconds, and sends the report again. The
control panel continues to repeat the report for a total of ten times. Some reports have zero as the second digit. In these
cases, only the first digit is sent, the control panel waits approximately three seconds, and then the report is repeated.
During the three-second delay between each report, pressing the [5] key on the phone's keypad acknowledges the report. The
control panel advances to the next event in the dialer queue and sends it in the same phone call, or hangs up if there are no
more events to report. When the control panel advances to the next report, it resets its count and sends the new report up to
ten times or until it is acknowledged.
If no one acknowledges the report after ten tries, the control panel hangs up and calls again. If two phone numbers are
programmed for the destination, the second phone number is called. The control panel follows the normal event phone routing.
For each event, the control panel tries five times or until the event is acknowledged. If no acknowledgement is received in the
five phone calls, the control panel logs a communication failure for the destination.
The control panel divides all possible events into Event Groups as reported to RPS. This event group selects which report to
send. The event groups are numbered 1 to 16. Events caused by RPS are not reported in the Personal Dialing Format. See
Table 47 on page 124. The column labeled "RPS Event Group" identifies each control panel event by its corresponding event
group number
• Address: See Table 38
• Default: See Table 38
• Selections: 0-15
Address
3414
3415
3416
3417
3418
3419
3420
3421
Use this parameter to select the tone for the 16 different Personal Dialing Format event groups.
Page 106 P/N: 4998152533-02
PART IV: CONTROL PANEL PROGRAMMING
Personal Dialing Default
Format Code
Duress 3
Fire Alarm 1
Non-fire Alarm 2
Reserved 0
Fire Trouble 5
Non-fire Trouble 6
Fire Restoral 0
Non-fire Restoral 0

Table 38: Personal Dialing Format Configuration

Copyright  2007 Bosch Security Systems, Inc.
Address Personal Dialing
Format Code
3422 RF Trouble
3423 Open/Close
3424 Installer Mode
3425 System Fault
3426 Test Report
3427 Reserved
3428 Bypass
3429 Output/User
Default
7
0
0
8
0
0
0
0
DS7200V2-UK Installer's Guide