Tests - Bosch DS7200V2-UK Installer's Manual

33.0

Tests

Automatic Test {137} Report Options
• Address: 0249
• Default: 0
• Selections: 0-4, 8-12
Automatic Test Report Options
No Automatic Test Report Options
Test Report Only if System is Armed
Defer Test Report if Other Report Sent in Test Interval
Test Reports for All Areas (else Area 1 only)
Call RPS at Test Time (after Test Report)
Use these options to configure the Automatic Test {137} report. If "Call RPS at Test Time" is enabled, a variety of tasks could
be accomplished at this time, including downloading the log to the ARC.
• Test Report Only If System is Armed: This option sends a test report only if the system is armed.
• Defer Test Report if Other Report Sent in Test Interval: If another report is sent during the test interval, this option defers
the test report until the end of the test interval.
• Test Reports for All Areas (else Area 1 only): If selected, this option generates a test report for all enabled areas. For the
DS7240V2, this option applies to Areas 1 through 4. For the DS7220V2, this option applies to Areas 1 and 2.
• Call RPS at Test Time (After Test Report): If selected, this option calls RPS at test time after the system sends the test
report. The Remote Programming Call Back Phone Number should be programmed. See page 45 for more information.
Automatic Test {137} Report Time
• Address: 0250-0253
• Default: 0000 (Test reports disabled)
• Selections: 0-9
Enter the time of day for the Automatic Test. Use 24-hour format (HHMM) where midnight is 2400, noon is 1200 and 12:01 am
is 0001. Enter one digit in each of the four addresses so that Addresses 0250 and 0251 are the hour, and 0252 and 0253 are
the minutes. An entry of 0000 (the default setting) disables the Automatic Test {137} report.
DS7200V2-UK Installer's Guide
0 1
•
•
Copyright  2007 Bosch Security Systems, Inc.
Enter This Data Digit to Select Options
2 3 4 5 6 7 8 9 10 11 12 13 14 15
• •
• •
•
• • • • •
PART IV: CONTROL PANEL PROGRAMMING
•
• •
•
P/N: 4998152533-02 Page 51