Use the following steps to install a DX2013 in the
CX1011 Enclosure:
1.
Insert the DX2013's angle bracket hooks into the
mounting slots in the back wall of the CX1011
Enclosure. See Figure 18.
Screw Hole
Hook
Slot
Enclosure Back Wall
Figure 18: Mounting the DX2013 (Step 1)
2.
Pull DX2013 down so that the angle bracket
hooks are flush in the mounting slots. See Figure
19.
Screw Hole
Hooks flush
with Slots
Enclosure Back Wall
Figure 19: Mounting the DX2013 (Step 2)
DS7200V2-UK Installer's Guide
Back of
Angle Bracket
Back of DX2013
Mounting Plate
Back of
Angle Bracket
Back of DX2013
Mounting Plate
Copyright 2007 Bosch Security Systems, Inc.
3.
Secure the DX2013 to the CX1011 enclosure
wall with a mounting screw (provided with
DX2013). See Figure 20.
Mounting Screw
Enclosure Back Wall
Figure 20: Mounting the DX2013 (Step 3)
18.3
DX2010 Wiring
Do not use twisted pair or shielded cable when
wiring the DX2010.
Refer to the following data bus wire length
requirements:
Power
Source
Aux Output
Control Panel
Not Used
Aux Output
Used
Aux Output
External
Used or Not
Power
Used
Supply
Table 5: DX2010 to Control Panel Wire Length
(#22 AWG)
Aux Output
Not Used
(1007.7 ft.)
Aux Output
Used
Table 6: DX2010 to External Power Supply Wire Length
PART II: SYSTEM INSTALLATION AND SETUP
Front of
Angle Bracket
Front of
DX2013
0.8 mm
1.2 mm
(#22 AWG)
(#18 AWG)
305 m
610 m
(1007.7 ft.)
(2001 ft.)
30 m
76 m
(98.4 ft.)
(249.3 ft.)
305 m
610 m
(1007.7 ft.)
(2001 ft.)
0.8 mm
1.2 mm
(#18 AWG)
305 m
610 m
(2001 ft.)
30 m
76 m
(98.4 ft.)
(249.3 ft.)
P/N: 4998152533-02
Page 19