Panasonic HG-S Series User Manual page 193

4.
Push the rubber bellows up with your finger until the tip of the spindle is exposed as shown
below.
5.
Attach the probe to the spindle.
The tightening torque should be 0.4N·m or less. Make sure that the probe does not come OFF.
When turning the probe screw, hold the cut face of the spindle with the provided sensor
head fastening wrench to prevent the spindle from turning.
Hold the sensor head fastening wrench in place, and turn only the probe.
6.
Make sure that the rubber bellows has not become deformed as shown below.
If the rubber bellows is deformed, restore the normal shape by rotating the bellows or otherwise.
If the rubber bellows is deformed, a load will occur when the spindle operates and damage
may result.
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
Spindle tip
Turn
APPENDIX
7-5