Panasonic HG-S Series User Manual page 167

<Reference>
● In the following cases, calibration cannot be executed. "ERROR" appears in the digital display /
MAIN (white).
No magnitude correlation between the target value and detected value (the signs of the
•
target value and detected value do not match).
• The adjustment factor that resulted from span adjustment was over twice the factory de-
fault span.
• The measured value is indeterminate ("------" appears).
The measured value is outside the measurement range ("+OVER" or "-OVER" appears).
•
Setting method
Long-press for 2 seconds
CALC: Only appears
Setting item
Calibration selection (CAL.SEL)
© Panasonic Industrial Devices SUNX Co., Ltd. 2019
on master unit
Default (DEFALT)
User settings (USER)
: Select
: Finalize
Set values
FUNCTION SETTINGS
Default value
DEFAUL
5-95