Force User Authentication Policy Add/Edit - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Chapter 34 User/Group
Table 162 User/Group > Setting (continued)
LABEL
User idle
timeout
Force User
Authentication
Policy
Total Policy
Policy per
page
Page x of x
#
Schedule
Source
Destination
Authenticate
Add icon
Apply
Reset

34.4.1 Force User Authentication Policy Add/Edit

Use this screen to specify a condition when users must log in or do not have to log in to the
ZyWALL before their HTTP traffic can pass through the ZyWALL.
512
DESCRIPTION
This is applicable for access users.
This field is effective when Enable user idle detection is checked. Type the
number of minutes each access user can be logged in and idle before the ZyWALL
automatically logs out the access user.
Use this section to specify when users must log in to the ZyWALL before the
ZyWALL routes HTTP traffic for them. Once users have logged in, the ZyWALL can
enforce user-aware policies.
This section displays the conditions that are applied, in sequence, to decide what
the appropriate action is. By default, users do not have to log in to the ZyWALL.
This is the number of entries configured.
Select how many entries to display per page in the screen.
This is the number of the page of entries currently displayed and the total number
of pages of entries. Type a page number to go to or use the arrows to navigate the
pages of entries.
This field is a sequential value, and it is not associated with a specific condition.
This field displays the schedule object that specifies when this condition applies. It
displays none if this condition always applies.
This field displays the source address object of traffic to which this condition
applies. It displays any if this condition applies to traffic from all source addresses.
This field displays the destination address object of traffic to which this condition
applies. It displays any if this condition applies to traffic from all destination
addresses.
This field displays whether users must log in (force) or whether users do not have
to log in (skip) when this condition is checked and satisfied.
This column provides icons to add, edit, move, and remove conditions. It also
provides icons to activate and deactivate conditions.
To add a condition, click the Add icon at the top of the column or next to each
condition. If you click the one at the top of the column, the new condition is first in
the list. If you click the one next to a condition, the new condition appears right
below this condition.
To edit a condition, click the Edit icon at the top of the column or next to each
condition. The Force User Authentication Policy Add/Edit screen appears.
To remove a condition, click on the Remove icon next to the condition. The web
configurator confirms that you want to delete the condition before doing so.
To move a condition up or down in the list, click on the Move to N icon next to the
condition, and type the line number (# field) where you want to move this condition.
The # field is updated accordingly.
To activate or deactivate a condition, click the Active icon next to the condition.
Make sure you click Apply to save and apply the change.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
ZyWALL USG 300 User's Guide