Add/Edit Policy Route - ZyXEL Communications VMG9827-B50A User Manual

Table 39 Network Setting > Routing >Policy Route (continued)
LABEL
Source
Interface
WAN Interface
Modify

9.4.1 Add/Edit Policy Route

Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use this
screen to configure the required information for a policy route.
Figure 69 Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 40 Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface Type the name of the interface from which the matched traffic is sent.
WAN Interface
OK
Cancel
Chapter 9 Routing
DESCRIPTION
This is the interface from which the matched traffic is sent.
This is the WAN interface through which the traffic is routed.
Click the Edit icon to edit this policy.
Click the Delete icon to remove a policy from the VMG. A window displays asking you to confirm
that you want to delete the policy.
DESCRIPTION
Select to enable or disable this policy route.
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the Broadband screens.
Click OK to save your changes.
Click Cancel to exit this screen without saving.
VMG4927-B50A / VMG9827-B50A / VMG3927-B50B User's Guide
138