Figure 38 Vpn Advanced Wizard: Step 2 - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Chapter 4 Wizard Setup

Figure 38 VPN Advanced Wizard: Step 2

The following table describes the labels in this screen.
Table 18 VPN Advanced Wizard: Step 2
LABEL
Remote
Gateway
Name
Secure
Gateway
My Address
(interface)
Authentication
Method
Pre-Shared
Key
102
DESCRIPTION
Type the name used to identify this VPN connection (and VPN gateway). You may
use 1-31 alphanumeric characters, underscores(
character cannot be a number. This value is case-sensitive.
Enter the WAN IP address or domain name of the remote IPSec router (secure
gateway) in the field below to identify the remote IPSec router by its IP address or a
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN
IP address.
Select an interface from the drop-down list box to use on your ZyWALL.
Type your pre-shared key in this field. A pre-shared key identifies a communicating
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to
share it with another party before you can communicate with them over a secure
connection.
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with "0x".
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not
used on both ends.
_ ), or dashes (-), but the first
ZyWALL USG 300 User's Guide