Table 69 Network > Routing > Static Route > Edit - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Chapter 12 Policy and Static Routes
The following table describes the labels in this screen.
Table 69 Network > Routing > Static Route > Edit
LABEL
Destination IP
Subnet Mask
Gateway IP
Interface
Metric
OK
Cancel
234
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host,
use a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
Enter the IP subnet mask here.
Select the radio button and enter the IP address of the next-hop gateway. The
gateway is a router or switch on the same segment as your ZyWALL's interface(s).
The gateway helps forward packets to their destinations.
Select the radio button and a predefined interface through which the traffic is sent.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL USG 300 User's Guide