Figure 169 Network > Http Redirect; Figure 170 Network > Http Redirect > Edit; Table 81 Network > Http Redirect; Table 82 Network > Http Redirect > Edit - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Figure 169 Network > HTTP Redirect
The following table describes the labels in this screen.
Table 81 Network > HTTP Redirect
LABEL
Name
Interface
Proxy Server
Port
Add icon
Apply
Reset
17.4 HTTP Redirect Edit
Click Network > HTTP Redirect to open the HTTP Redirect screen. Then click the Add or
Edit icon to open the HTTP Redirect Edit screen where you can configure the rule.
Figure 170 Network > HTTP Redirect > Edit
The following table describes the labels in this screen.
Table 82 Network > HTTP Redirect > Edit
LABEL
Enable
Name
ZyWALL USG 300 User's Guide
DESCRIPTION
This is the descriptive name (up to 31 printable characters) of a rule.
This is the interface on which the request must be received.
This is the IP address of the proxy server.
This is the service port number used by the proxy server.
Click the Add icon in the heading row to add a new entry.
The Active icon displays whether the rule is enabled or not. Click the Active icon to
activate or deactivate the rule. Make sure you click Apply to save and apply the
change.
Click the Edit icon to go to the screen where you can edit the rule on the ZyWALL.
Click the Remove icon to delete an existing rule from the ZyWALL. A window
displays asking you to confirm that you want to delete the rule.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Use this option to turn the HTTP redirect rule on or off.
Enter a name to identify this rule. You may use 1-31 alphanumeric characters,
underscores( _ ), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Chapter 17 HTTP Redirect
263