Figure 51 Status > Interface Status Summary, After Ethernet Interface Edits; Figure 52 Network > Interface > Trunk, Initial; Figure 53 Network > Interface > Trunk > Edit, Initial; Table 31 Trunk Example - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Figure 51 Status > Interface Status Summary, After Ethernet Interface Edits

6.1.3 WAN Trunk

This example sets up trunk WAN_TRUNK with ge3 and ge4. This example uses the default
settings for the trunk and shows how to add the interfaces to it.

Table 31 Trunk Example

ETHERNET
INTERFACE
ge1
ge3
ge4
ge5
There are no existing trunks at the beginning of this example.
1 Click Network > Interface > Trunk. The following screen appears.
Figure 52 Network > Interface > Trunk, Initial
2 Click the Edit icon. The following screen appears.
Figure 53 Network > Interface > Trunk > Edit, Initial
3 Click the Member icon, as shown above. Select the ge2 and click the left arrow to
remove it from the member list. Do the same for aux. Select ge4 and click the right
arrow to add it to the member list. Then click OK.
ZyWALL USG 300 User's Guide
TRUNK
---
WAN_TRUNK
WAN_TRUNK
---
Chapter 6 Tutorials
129