Add/Edit Policy Route - ZyXEL Communications EX3510-B0 User Manual

9.4.1 Add/Edit Policy Route

Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use this
screen to configure the required information for a policy route.
Figure 83 Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 43 Policy Route: Add/Edit
LABEL
Active
Route Name
Source IP
Address
Source Subnet
Mask
Protocol
Source Port
Source MAC
Source Interface
(ex: br0 or
LAN1~LAN4)
WAN Interface
Chapter 9 Routing
DESCRIPTION
Click this switch to enable or disable the policy route. When the switch goes to the right
function is enabled. Otherwise, it is not.
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Enter the source IP address.
Enter the source subnet mask address.
Select the transport layer protocol (TCP or UDP).
Enter the source port number.
Enter the source MAC address.
Type the name of the interface from which the matched traffic is sent.
This field shows ETHWAN as the WAN interface through which the traffic is sent.
EX3510-B0 User's Guide
143
, the