Table 53 Network > Interface > Vlan > Edit - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Each field is explained in the following table.
Table 53 Network > Interface > VLAN > Edit
LABEL
VLAN Interface
Properties
Enable
Interface Name
Port
Virtual LAN Tag
Description
IP Address
Assignment
Get
Automatically
Use Fixed IP
Address
IP Address
Subnet Mask
Gateway
Metric
Interface
Parameters
Upstream
Bandwidth
Downstream
Bandwidth
MTU
DHCP Setting
ZyWALL USG 300 User's Guide
DESCRIPTION
Select this to enable this interface. Clear this to disable this interface.
This field is read-only if you are editing the interface. Enter the name of the
VLAN interface. The format is vlanx, where x is 0 - 31. For example, vlan0,
vlan8, and so on.
Select the Ethernet interface on which the VLAN interface runs.
Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN. Allowed
values are 1 - 4094. (0 and 4095 are reserved.)
Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and ()+/:=?!*#@$_%-
characters long.
Select this if this interface is a DHCP client. In this case, the DHCP server
configures the IP address, subnet mask, and gateway automatically.
You should not select this if the interface is assigned to a VRRP group. See
Chapter 33 on page 493.
Select this if you want to specify the IP address, subnet mask, and gateway
manually.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address for this interface.
This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of this interface in dot decimal notation. The subnet
mask indicates what part of the IP address is the same for all computers in the
network.
This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL sends packets to the
gateway when it does not know how to route the packet to its destination. The
gateway should be on the same network as the interface.
Enter the priority of the gateway (if any) on this interface. The ZyWALL decides
which gateway to use based on this priority. The lower the number, the higher
the priority. If two or more gateways have the same priority, the ZyWALL uses
the one that was configured first.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
send through the interface to the network. Allowed values are 0 - 1048576.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can
receive from the network through the interface. Allowed values are 0 - 1048576.
Maximum Transmission Unit. Type the maximum size of each data packet, in
bytes, that can move through this interface. If a larger packet arrives, the
ZyWALL divides it into smaller fragments. Allowed values are 576 - 1500.
Usually, this value is 1500.
Chapter 10 Interface
characters, and it can be up to 60
201