Figure 141 Network > Interface > Auxiliary; Table 61 Network > Interface > Auxiliary - ZyXEL Communications Unified Security Gateway ZyWALL 300 User Manual

Chapter 10 Interface
Figure 141 Network > Interface > Auxiliary
Each field is described in the table below.
Table 61 Network > Interface > Auxiliary
LABEL
Auxiliary Interface
Properties
Enable
Description
Port Speed
Dialing Type
Initial String
Auxiliary
Configuration
Phone Number
User Name
Password
Retype to
confirm
216
DESCRIPTION
Select this to turn on the auxiliary dial up interface. The interface does not dial
out, however, unless it is part of a trunk and load-balancing conditions are
satisfied.
Enter a description of this interface. It is not used elsewhere. You can use
alphanumeric and ()+/:=?!*#@$_%-
characters long.
Select the speed of the connection between the ZyWALL and external
computer.
Tone - select this if the telephone uses tone-based dialing.
Pulse - select this if the telephone uses pulse-based dialing.
Enter the AT command string to initialize the external modem.
common string, but you should check the manual for the external modem for
additional commands.
Enter the phone number to dial here. You can use 1-20 numbers, commas (,),
or plus signs (+). Use a comma to pause during dialing. Use a plus sign to tell
the external modem to make an international call.
Enter the user name required for authentication.
Enter the password required for authentication.
Enter the password again to make sure you have not typed it incorrectly.
characters, and it can be up to 60
ATZ is the most
ZyWALL USG 300 User's Guide