Figure 7: Crane lug dismounted
Bolts and nuts are delivered with the lifting lugs and must be tightened with the torque according to
Table 2. If the lifting lugs are already mounted by TRANE, the bolts must be checked before lifting
of the AHU.
Table 2: Tightening torque for bolts
3.3.3
Lifting of CCE Compact AHU by crane lugs
The load effect has to take place uniformly across all four crane lugs.
-
The definition of the load carrying equipment is the responsibility of the executing company.
-
The correct guidance of the load carrying equipment according to Figure 10 must be observed.
-
After the pre-positioning of the delivery section at the desired position, remove the lifting lugs
-
and use them for the next delivery section.
V07-19.0
Base frame height
Figure 9: Base frame height
Base frame height H (mm)
80
Figure 8: Crane lug mounted
Bolt type
Nm
M8x20
10
19/115