Line with submenu
An arrow right next to the line indicates a submenu; the line can be selected with the rotary button
and the submenu can be entered with Ok.
Value, setpoint
Select the line of the setpoint to be changed and confirm with Ok; a new page displays the setpoint
with the limits and the location of the setpoint within the limits with an arrow on the bar.
Keep turning the rotary button until the desired value is set to change a value; after prolonged turn-
ing the active position will automatically switch to the next higher (once 10 numbers have been run
through); if the rotary button is not turned for some seconds, the active position will switch back to
the next lower. For better orientation this is illustrated by an arrow above the number. Thus, large
numerical ranges are adjusted quickly.
Selection, setting, function
Select the line of the setting / selection / function to be changed with the rotary button and confirm
new setting with the rotary button and confirm with Ok.
ESC-button
The ESC-button has different functions:
•
During the change of a setpoint or setting, this will be cancelled and the old value is retained
•
Within a menu to return to the next higher menu
•
By pressing and holding the button, the system page of the display is called up; there the
color, contrast and brightness of the backlighting can be changed
V07-19.0
2500
0m3/h
Figure 83: Set value, setpoint
Supply
Return
RoomCasc
Room
Figure 84: Selection (e.g. supply air control)
m3/h
5000m3/h
1/5
63/115