Table of Contents
Advertisement
In addition to the actions mentioned here, the instructions according to chapter
-
3.4 (Further necessary actions for the overlifting of both, delivery sec-
tions on crane lugs as well as monoblocs) have to be observed.
-
Parts of the AHU may only be lifted with lugs individually - never bolt parts to-
gether before lifting.
Lateral load on lifting lugs is not allowed.
-
3.3.1
Weight specifications of CCE Compact AHUs and additional parts
Depending on the AHU type, the AHU or additional sections have following weights, see Table 1.
The delivered crane lugs may be used for lifting CCE Compact AHUs which have these maximum
weights. It is required, that the weight is equally distributed on all 4 correctly mounted crane lugs. If
there are more than one AHU part, they must be lifted separately.
basic AHU with plate heat exchanger
basic AHU with heat wheel
optional chiller (additional part)
optional E-heating coil (additional part)
Table 1: Weight specifications CCE Compact basic AHUs and additional parts
3.3.2
Mounting of crane lugs
4 crane lugs are supplied in two versions – mirror inverted. These lugs must be mounted at the spe-
cific positions at the base frame of the AHU.
Execution of the lifting lugs (see Figure 6):
1. Right-side type
2. Left-side type
Attention to correct mounting of the crane lug according Figure 8.
18/115
type 45
weight in kg
Figure 6: Right-side and left-side crane lifting lug
type 55
weight in kg
380
480
355
465
80
100
115
140
type 65
weight in kg
660
650
120
155
V07-19.0
Advertisement
Table of Contents
