Table of Contents
Advertisement
Siphon on pressure side (in direction of airflow after the fan), see Figure 62.
H3 (mm) > p (mm WS)
H4 (mm) ≥ 0
6.2.2
Ball siphons
If ball siphons with the below shown design are supplied by TRANE, then the following instructions
should be observed during installation:
Depending on the suction side or pressure side mounting position, the siphon body has to be in-
stalled so that the direction of the arrow (see Figure 63) corresponds to the flow direction.
- Pa
=
+ Pa
=
Figure 63: Observe the mounting position - flow direction according to the arrow
38/115
Figure 61: Siphon on suction side
Figure 62: Siphon on pressure side
suction side
pressure side
V07-19.0
Advertisement
Table of Contents
