Map/Out - Output - Yamaha A3000 Owner's Manual

MAP/OUT Function

MAP/OUT - Output

Sets the sample's output destinations and output levels.
PLAY PROGRAM
EDIT TRIM / LOOP
REC RECORD
DISK PROGRAM
UTILITY TOTAL EQ
Turn action
Push action
Knob 1
Knob 2
Knob 3
Chapter 5 EDIT Mode
176
SAMPLE EASY EDIT EFFECT SETUP
MAP / OUT FILTER EG LFO
SETUP METER EFFECT EXT CTRL
SAMPLE SEQUENCE VOLUME DISK
PANEL PLAY SEQUENCE MASTER SYSTEM
Knob 1
Use this page to set the sample's main and assignable output destinations, and the out-
put level to each.
Change Page
• Turn the knob to change to a different page within the MAP/OUT function. Available
pages are: KeyRnge, VelRnge, Lvl&Mode, Output (this page), Pitch, Expand, and LvlScale.
• Push the knob to move to the Program/Sample Selection screen. ( 95)
MainOut
Selects the sample's main output destination. Available settings are as follows.
off
Stereo
Effect1,...,Effect3
Level
Sets the output level to the main output.
CONTROL
MIDI / CTRL
Turn Knob 1 to select Output.
MONITOR
IMPORT
MIDI
Knob 2 Knob 3
- -
= off, Stereo, Effect1, Effect2, Effect3
The signal does not flow to any main output. Use this setting
when you want to output the sample through assignable outputs
only (see below).
Output the sample signal directly to the stereo outputs, bypass-
ing all effects.
Pass the sample's signal through the selected effect block (Ef-
fect 1, Effect 2, or Effect 3), then output the result to the stereo
outputs.
= 0,...,127
Knob 4 Knob 5
--
Select P/S