Sample - Tobank (Assign Sample To Bank) - Yamaha A3000 Owner's Manual

SAMPLE - ToBank (Assign Sample to Bank)

Places a sample into a sample bank.
PLAY PROGRAM SAMPLE EASY EDIT
EDIT TRIM / LOOP MAP / OUT FILTER
REC RECORD SETUP METER
DISK PROGRAM SAMPLE SEQUENCE
UTILITY TOTAL EQ PANEL PLAY SEQUENCE
Turn action
Push actio
Use this page to set samples into sample banks.
FYI
• You cannot use this page to create a new sample bank. To create a sample bank, use
• To remove a sample from a sample bank, use the REMOVE page. ( 114)
Knob 1 Change Page
• Turn the knob to change to a different page within the SAMPLE function. Available
• Push the knob to move to the Program/Sample Selection screen. ( 95)
Knob 2 Sample bank
• Turn this knob to select the destination sample bank.
• If you select a new or edited sample bank that has not yet been saved to disk in its
Sample
Knobs 3, 4
• Turn either knob to select the sample that you want to add to the sample bank.
• If you wish to set or change the name of the selected sample, push either knob to
EFFECT SETUP CONTROL
EG LFO MIDI / CTRL
EFFECT EXT CTRL MONITOR
VOLUME DISK IMPORT
MASTER SYSTEM MIDI
Knob 1 Knob 2
-
the NEWBANK command page instead (press the COMMAND key and go to the
>NEWBANK command page). ( 105).
pages are: SmpSel, SmpBank, ToBank (this page), and SmpSort.
= bank name
current form, an [E] ("edited") mark appears in front of the name.
= sample name
proceed to the name-editing screen. For information about how to edit name strings,
see "Entering Names" ( 88).
SAMPLE Function
Turn Knob 1 to select ToBank.
Knob 3 Knob 4
Select P/S
Edit the Name
Chapter 4
Knob 5
-
PLAY Mode
115